The short version of Reversed-phase HPLC fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-06-06. Anything still debated is marked as such rather than presented as settled.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
The mechanisms attributed to semax are inferred from animal and cell studies rather than traced to one confirmed target. The most frequently cited pathway involves increased expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal and cortical tissue. Some work points to engagement of melanocortin receptors, particularly MC4, which the parent ACTH fragment can activate. Effects on dopaminergic and serotonergic signalling have also been reported. No single account explains all observed results, and the relative weight of each pathway remains unsettled.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Though originally planned to be presented at a ceremony at the Queen Elizabeth Hall in London, the event was instead presented as a live stream on 2 April 2020 due to concern over the COVID-19 pandemic.
==== Granule membrane fusion ==== The mast cell granule can now fuse with the plasma membrane. This is mediated by Soluble N-ethylmaleimide-sensitive factor attachment protein receptors (SNARE) proteins. Different SNARE proteins interact to form different complexes that catalyze fusion.
=== Detection in body fluids === Lorazepam may be quantitated in blood or plasma to confirm poisoning in hospitalized people, provide evidence of an impaired driving arrest or to assist in a medicolegal death investigation. Blood or plasma concentrations are usually in a range of 10–300 μg/L in persons either receiving the drug therapeutically or in those arrested for impaired driving. Approximately 300–1000 μg/L is found in people after acute overdosage. Lorazepam may not be detected by commonly used urine drug screenings for benzodiazepines. This is due to the fact that the majority of these screening tests are only able to detect benzodiazepines that undergo oxazepam glucuronide metabolism.
Sources: en.wikipedia.org
===== Erection angle ===== Although many erect penises point upwards, it is common and normal for erect penis to curve in any direction. Many penises are curved in right, left, upwards or downwards direction depending upon the tension of the suspensory ligament that holds it in position. The following table shows how common various erection angles are for a standing male, out of a sample of 81 males aged 21 through 67. In the table, zero degrees is pointing straight up against the abdomen, 90 degrees is horizontal and pointing straight forward, while 180 degrees would be pointing straight down to the feet. An upward pointing angle is most common.
RNA is synthesized from template DNA by RNA polymerase with messenger RNA (mRNA) serving as the intermediary biomolecule between DNA expression and protein translation. Because of its unique properties (such as its typically single-stranded nature and its 2' OH group) and its ability to adopt many different secondary/tertiary structures, both coding and noncoding RNAs have attracted attention in medicine. Research has begun to explore RNAs potential to be used for therapeutic benefit, and unique challenges have occurred during drug discovery and implementation of RNA therapeutics.
Later, in 1687 in the Philosophiæ Naturalis Principia Mathematica, Newton showed mathematically that in an elastic fluid consisting of particles at rest, between which are repulsive forces inversely proportional to their distance, the density would be directly proportional to the pressure, but this mathematical treatise does not involve any Mariott temperature dependence and is not the proper physical explanation for the observed relationship. Instead of a static theory, a kinetic theory is needed, which was developed over the next two centuries by Daniel Bernoulli (1738) and more fully by Rudolf Clausius (1857), Maxwell and Boltzmann. This law was the first physical law to be expressed in the form of an equation describing the dependence of two variable quantities.
== Biography == Robert Allan Humphreys was born on October 16, 1930, in Chickasha, Oklahoma, to Ira Denver Humphreys and Stella Bernice Humphreys. "Laud" was chosen as his first name when he was baptized again upon entering the Episcopal Church.
Sources: en.wikipedia.org
== References == McGraw-Hill Encyclopedia of Science & Technology (10th ed.). New York: McGraw-Hill. 2007. ISBN 978-0-07-144143-8. Serway, Raymond A.; Moses, Clement J.; Moyer, Curt A. (1989), Modern Physics, Fort Worth: Harcourt Brace Jovanovich, ISBN 0-03-004844-3 Simmons, George F. (1972), Differential Equations with Applications and Historical Notes, New York: McGraw-Hill, LCCN 75173716
=== Environmental chemistry === An important goal of environmental chemistry is tracing the source and degradation of pollutants. Various methods have been used for fingerprinting pools of environmental pollutants such as the bulk chemical composition of a spill, isotope ratios of the bulk chemical mixture, or isotope ratios of individual constituent compounds. Stable isotopes of carbon and hydrogen can be used as complementary fingerprinting techniques for natural gas. The DHR of hydrocarbons from the Deepwater Horizon oil spill was used to verify that they were likely from the Macondo well. HICs have also been used as a measure of the relative amount of biodegradation that has occurred in oil reservoirs in China, and studies on pure cultures of n-alkane degrading organisms have shown a chain-length dependence on the amount of hydrogen isotope fractionation during degradation. Additional studies have also shown hydrogen isotope effects in the degradation of methyl tert-butyl ether and toluene that have been suggested to be useful in the evaluation of the level of degradation of these polluting compounds in the environment. In both cases the residual unreacted compounds became 2H-enriched to a few tens of ‰, with variations exhibited between different organisms and degree of reaction completeness. These observations of heavy residual compounds have been applied to field observations of biodegradation reactions such as removal of benzene and ethylbenzene, which imparted a D/H fractionation of 27 and 50 ‰, respectively.
=== Infrared ear thermometers === Diatek Corporation and NASA developed an aural thermometer that measures the thermal radiation emitted by the eardrum, similar to the way the temperature of stars and planets are measured. This method avoids contact with mucous membranes and permits rapid temperature measurement of newborn or incapacitated patients. NASA supported the Diatek Corporation through the Technology Affiliates Program.
Each medal has a portrait of Alfred Nobel in left profile on the obverse. The medals for Chemistry, Literature, Physics, and Physiology or Medicine have identical obverses, showing the image of Nobel and the years of his birth and death. Nobel's portrait also appears on the obverse of the Peace Prize medal and the Economics Prize medal, but with a slightly different portrait. The names of the chemistry, medicine, literature and physics prize recipients are engraved on the reverse of the medal on a small plate. The names of the peace and economic prize recipients are engraved on the edges of their medals. The Chemistry, Literature, Physics, and Physiology or Medicine medals were designed by Erik Lindberg. The Peace prize medal was designed by Gustav Vigeland, and the Economics prize medal by Gunvor Svensson-Lundqvist. The inaugural Nobel laureates of 1901 received a 'temporary' medal that was struck in a lesser metal than gold. The first medals were eventually struck in September 1902. The delay was due to the designs needing to be approved by each respective awarding institution. The medals were designed by the sculptor Erik Lindberg. Between 1902 and 2010 the Nobel Prize medals were struck by the Myntverket, the Swedish royal mint, located in Eskilstuna. In 2011 the medals were made by Det Norske Myntverket in Kongsberg. The medals have been made by Svenska Medalj in Eskilstuna since 2012 with the exception of the peace prize medal which is made by the Det Norske Myntverket.
Disease-modifying antirheumatic drugs (DMARDs), such as hydroxychloroquine and methotrexate, may be used to try to slow the progression of disease. Biological DMARDs may be used when the disease does not respond to other treatments. However, they may have a greater rate of adverse effects. Surgery to repair, replace, or fuse joints may help in certain situations. Rheumatoid arthritis affects about 17.6 million people globally, as of 2020. This is 0.5–1% of adults in the developed world with between 5 and 50 per 100,000 people newly developing the condition each year. Onset is most frequent during middle age and women are affected 2.5 times more than men. It resulted in 38,300 deaths in 2020, up from 28,000 deaths in 1990. The first recognized description of RA was made in 1800 by Dr. Augustin Jacob Landré-Beauvais (1772–1840) of Paris. The term rheumatoid arthritis is based on the Greek words for watery and inflamed joints (from Ancient Greek ῥεῦμα (rheûma) 'flowing current', with arthritis derived from arthr- (meaning 'joint') and -itis (meaning 'inflammation')).
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Suppliers normally quote a percentage of total chromatographic peak area, most often from reversed-phase HPLC. That figure says nothing about what the remaining percentage contains, and it depends on the detection wavelength used. A mass spectrometry result is a separate and stronger check on identity.