A practical reference on methionine sulfoxide: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. Its design combines the ACTH(4-7) core fragment with a C-terminal Pro-Gly-Pro extension, a modification intended to improve stability and prolong activity. The molecule is hydrophilic, carries no lipid chains or glycosylation, and has a theoretical mass just over 810 daltons in its free form. All seven residues are proteinogenic amino acids, so no non-natural building blocks appear in the backbone. A free N-terminal methionine and C-terminal proline define the unmodified parent peptide.
The compound was developed during the 1980s at the Institute of Molecular Genetics in Moscow as part of research on fragments of adrenocorticotropic hormone. Early work examined short ACTH-derived sequences that retained neurotrophic effects while lacking the endocrine activity of the full hormone. Semax entered clinical use in Russia during the 1990s, where it received registration for several neurological indications. Outside that region it remained primarily a laboratory research material rather than an approved therapeutic. English-language literature on it grew more slowly and frequently cited the original Russian studies.
Terminology around the compound varies by source. It appears in catalogues and papers as Semax, as the heptapeptide ACTH(4-7)-Pro-Gly-Pro, and under various alphanumeric laboratory codes used by individual suppliers. These names refer to the same sequence but may imply different salt forms, purity grades, or counter-ions. Peptide databases usually list the free base mass, while product descriptions sometimes report acetate or trifluoroacetate salts with a different formula weight. Because naming conventions for research peptides are not standardised across vendors, checking the declared sequence and measured mass is more reliable than relying on a trade name alone.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Identity and purity are confirmed with reversed-phase high-performance liquid chromatography, typically monitored at 214 nanometres where the peptide bond absorbs. Mass spectrometry, either electrospray or MALDI-TOF, verifies molecular mass against the theoretical value and detects truncation or adduct formation. Amino acid analysis and peptide mapping provide additional confirmation when required. The most frequently reported impurities are deletion sequences from incomplete coupling, methionine sulfoxide from oxidation, and dimeric species formed through non-covalent aggregation. Impurity profiles depend strongly on the synthesis and purification route chosen by the producer.
Published research has focused mainly on neurological and cognitive endpoints in animal models, with proposed mechanisms involving brain-derived neurotrophic factor and related signalling pathways. A substantial share of the human data originates from a limited number of research groups, and independent replication in other countries remains sparse. Regulatory status reflects that distribution: the peptide is registered as a medicine in Russia and appears in some neighbouring markets, while elsewhere it is handled as a research chemical without approved therapeutic labelling. Questions about dose-response relationships, long-term effects, and comparability across studies are still open.
Lyophilised powder is normally kept at -20 °C in a desiccated container, with some suppliers recommending -80 °C for long-term archival storage. Repeated freeze-thaw cycles are the most common cause of avoidable loss, so aliquoting before freezing reduces variability between working sessions. Dissolved peptide is far less stable than the dry solid and is usually prepared fresh or held briefly at 4 °C. Aqueous solutions support both hydrolysis of the backbone and oxidation of the N-terminal methionine, and these two routes dominate degradation under ordinary laboratory conditions.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It is described in the literature as an analogue of the ACTH(4–10) fragment, a short N-terminal portion of adrenocorticotropic hormone that retains some neurotropic activity without the full hormonal effects of the parent peptide. The molecule carries a methionine residue at the N-terminus and two proline residues near the C-terminus, features that shape both its interactions with receptor systems and its chemical stability. The free peptide corresponds to the formula C37H51N9O10S and a molecular mass near 813.9 Da.
The compound was developed in the 1980s at the Institute of Molecular Genetics in Moscow, where it emerged from research on short ACTH fragments and their effects on the central nervous system. Russian pharmaceutical listings describe it as a nootropic and neuroprotective agent, most often formulated as nasal drops. It is not a marketed medicine in the United States or the European Union, and no pharmacopoeial monograph covers it. Consequently, most published clinical experience with the substance originates from a small number of research centres, mainly in Russia and neighbouring countries.
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Solid semax is typically supplied as a lyophilised powder that is hygroscopic and sensitive to moisture, light, and repeated temperature cycling. Long-term storage of the dry peptide is generally recommended at approximately -20 degrees Celsius, while shorter working periods may use refrigeration at 2 to 8 degrees Celsius. Vials should remain tightly closed and desiccated when brought to room temperature, because condensation can damage the material before it is weighed. Dividing a batch into aliquots is preferable to thawing one container repeatedly.
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
=== Mesocolon regions === The transverse mesocolon is that section of the mesentery attached to the transverse colon that lies between the colic flexures. The sigmoid mesocolon is that region of the mesentery to which the sigmoid colon is attached at the gastrointestinal mesenteric margin. The mesoappendix is the portion of the mesentery connecting the ileum to the appendix. It may extend to the tip of the appendix. It encloses the appendicular artery and vein, as well as lymphatic vessels, nerves, and often a lymph node. The mesorectum is that part attached to the upper third of the rectum.
In the aftermath, Naram-Sin deified himself as well as posthumously deifying Sargon and Manishtushu but not his uncle Rimush. The echoes of the revolt were reflected in later Sumerian literary compositions such as the Great Revolt against Naram-Sin, "Naram-Sin and the Enemy Hordes" and "Gula-AN and the Seventeen Kings against Naram-Sin".
Francis Aston was born in Harborne, now part of Birmingham, on 1 September 1877. He was the third child and second son of William Aston and Fanny Charlotte Hollis. He was educated at the Harborne Vicarage School and later Malvern College in Worcestershire where he was a boarder. In 1893 Francis William Aston began his university studies at Mason College (which was then external college of University of London) where he was taught physics by John Henry Poynting and chemistry by Frankland and Tilden. From 1896 on he conducted additional research on organic chemistry in a private laboratory at his father's house. In 1898 he started as a student of Frankland financed by a Forster Scholarship; his work concerned optical properties of tartaric acid compounds. He started to work on fermentation chemistry at the school of brewing in Birmingham and was employed by W. Butler & Co. Brewery in 1900. This period of employment ended in 1903 when he returned to the University of Birmingham under Poynting as an Associate.
Sources: en.wikipedia.org
Aspirin: may increase valproate concentrations. May also interfere with valproate's metabolism. Benzodiazepines: may cause CNS depression and there are possible pharmacokinetic interactions. Carbapenem antibiotics: reduce valproate levels, potentially leading to seizures. Cimetidine: inhibits valproate's metabolism in the liver, leading to increased valproate concentrations. Erythromycin: inhibits valproate's metabolism in the liver, leading to increased valproate concentrations. Ethosuximide: valproate may increase ethosuximide concentrations and lead to toxicity. Felbamate: may increase plasma concentrations of valproate. Mefloquine: may increase valproate metabolism combined with the direct epileptogenic effects of mefloquine. Oral contraceptives: may reduce plasma concentrations of valproate. Primidone: may accelerate metabolism of valproate, leading to a decline of serum levels and potential breakthrough seizure. Rifampicin: increases the clearance of valproate, leading to decreased valproate concentrations. Warfarin: valproate may increase free warfarin concentration and prolong bleeding time. Zidovudine: valproate may increase zidovudine serum concentration and lead to toxicity.
==== E ==== Powdered eggs – are fully dehydrated eggs made using spray drying in the same way that powdered milk is made. Powdered eggs have a storage life of 5 to 10 years when stored without oxygen in a cool environment. Another dried egg product is freeze-dried eggs, which can be shelf-stable for up to 25 years.
UV degradation is one form of polymer degradation that affects plastics exposed to sunlight. The problem appears as discoloration or fading, cracking, loss of strength or disintegration. The effects of attack increase with exposure time and sunlight intensity. The addition of UV absorbers inhibits the effect.
=== Neural sources === In the hypothalamus, oxytocin is made in magnocellular neurosecretory cells of the supraoptic and paraventricular nuclei, and is stored in Herring bodies at the axon terminals in the posterior pituitary. It is then released into the blood from the posterior lobe (neurohypophysis) of the pituitary gland. These axons (likely, but dendrites have not been ruled out) have collaterals that innervate neurons in the nucleus accumbens, a brain structure where oxytocin receptors are expressed. The endocrine effects of hormonal oxytocin, and the cognitive or behavioral effects of oxytocin neuropeptides are thought to be coordinated through its common release through these collaterals. Oxytocin is also produced by some neurons in the paraventricular nucleus that project to other parts of the brain and to the spinal cord. Depending on the species, oxytocin receptor-expressing cells are located in other areas, including the amygdala and bed nucleus of the stria terminalis. In the pituitary gland, oxytocin is packaged in large, dense-core vesicles, where it is bound to neurophysin I as shown in the inset of the figure; neurophysin is a large peptide fragment of the larger precursor protein molecule from which oxytocin is derived by enzymatic cleavage. The electrical activity of the oxytocin cells in the hypothalamus regulates the secretion of oxytocin from the neurosecretory nerve endings.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is a synthetic seven-amino-acid peptide built from the ACTH(4-7) sequence plus a Pro-Gly-Pro tail. It belongs to the family of short ACTH fragments studied for nervous-system effects. Its backbone contains only standard amino acids.